# Change Log
All notable changes to this project will be documented in this file.

The format is based on [Keep a Changelog](http://keepachangelog.com/).

## [Unreleased]

### Added
- Added four test-points to the track short system to allow production testing of actual resistive losses in MOSFETs

## [2.3] - 2019-03-20

### Added
- Added Listen/Send control to both CAN drivers to the MCU
- R76 and R77 to allow for listen/send control
- Several Test-Points, among which the test-points to apply battery voltages
- Enabled some quite sensible design rules that were apparently never enabled. Then also cleaned up the mess it found.

## [2.2] - 2018-11-28

### Added
- Added a non-fitted I2C thermal sensor to the main I2C bus.

## [2.1] - 2018-10-10

### Changed
- Changed the 1.75Vref op-amp the right way around wrt the -vin and +vin.
- Moved the Switch connector 3.5mm inward for assembly purposes.

## [2.0] - 2018-08-01

### Changed
- Set version strapping to 2.0 due to pin change.
- Battery Disable is now inverted logic and should become an open-collector.
- Battery 1 gets disabled automatically when Vbat2 is above 6.06V. 
- Higher value pull-up/-down resistors in battery select circuit.
- MCU VddA filtered separately through a resistor, to prevent oscillations.
- LED connector changed from screw-type to WE Micro-Fit/Mini-Fit standard connector.

## [1.3] - 2017-12-22

### Changed
- Moved the headers away from dangerous or complicated locations.
- Added the new UI Panel interface. (UI Button at PB15/Pin36 on uC)
- Updated DNCM Supports for manufacturability
- Charger has a diode that supports a 12V battery with 15V DC input, using these parameters with earlier versions invites a reasonable risk of damage